1. Using an Allen key wrench, unscrew the bolt that is passing through that handle and pull the handle off of the control arm shaft.2. Push the cont
6. With the up and down control lines loose, pull on them and re-move them from the hull with the tubes. If they get hung up inside the hull, you ca
11. Now feed the UP control line through the same two holes above the rudder pin to the inside of the rudder housing. Wrap the line so that it goes
16. Drill a hole in the dotted location with a 5/16” drill bit17. Insert one of the two the small length of rigid tube into the hole and press the b
18. Locate the cleat on the right side map pocket just like in step 7 and use the holes in the cleat as a guide to drill two 11/64” holes through the
23. Through bolt the two pulleys on the inside of the kayak. On the RIGHT side of the kayak, use the existing screws that are being used to attach t
28. Pull the lines all the way back to the rear hatch and tie a simple knot approximately 4” from the end of the lines.29. Now you are going to lock
29. Your up/ down rudder system is now ready to goa. Pull on the right “T” handle to lower the rudder. Pull the line tight and cleat off to hold it
Kommentare zu diesen Handbüchern